Setup Network Bridge Using NetworkManager (Centos 7)

sxhow Gnome, Networking, ,

After creating the bridge in NetworkManager, add the following to the ifcfg-eth-xxx for the actual adapter chosen in NetworkManager:

BRIDGE=

Then restart NetworkManager. May take a bit of time to DHCP the bridge.

Note:
With this setup, the ethernet adapter will not configure any IP address, so no changes are needed for that.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

Gravatar
WordPress.com Logo

You are commenting using your WordPress.com account. ( Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. ( Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. ( Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. ( Log Out /  Change )

w
Cancel

Connecting to %s